The mcr Sil-MU seal is designed to be used wherever reduced mechanical strength is required, e.g. on wood, steel and aluminium fire doors, fire doors for special areas of application, as well as for ventilation and smoke exhaust ducts, cable ducts, the sealing of windows, facades and others.
The mcr Sil-MU intumescent seal is made of hydrated calcium silicate reinforced with glass fibre, covered with a layer of epoxy resin on both sides. It is activated in temperatures between 100°C and 120°C to form a rigid, non-combustible foam which provides a high level of thermal insulation. It expands in one direction to at least five times its original thickness. The swell pressure generated in the process may reach 1.5 N/mm2. This provides an effective barrier to escaping flames, smoke and hot gases around the circumference of the component, where the seal is installed.
GENERAL |
|
Product Type |
intumescent gasket |
Reaction to fire |
A2 class non-flammability |
Appearance |
rolled strips with a total length of 2,100 mm long, 30 mm wide and 2 mm thick |
Dimensions |
length 2,100 mm / width 30 mm ± 0.5 mm / thickness 2 mm ± 0.4 mm |
PHYSICAL FEATURES |
|
Swelling height (10 minutes at 550°C under fire load) |
>5 x original height |
Swelling pressure |
≥ 0.9 N/mm2 |
Thermal conductivity at 20°C |
0.8 W/mK |
Water content |
from 25% to 40% by weight |
Areal weight (average) |
3.0 kg/m2 |
The surface to be protected with the mcr Sil-MU seal should be clean and dry. Remove any loose paint from the surface.
The seal can be fixed by gluing, but also with the use of a double-sided adhesive tape or any mechanical fasteners.
Store in a dry place at temperatures of –20°C to +40°C.
Ten serwis wykorzystuje pliki cookies. Jeśli nie zgadzasz się na korzystanie przez serwis z plików cookies, zmień ustawienia przeglądarki zgodnie z niniejszą polityką cookies
+420 597 317 665
Letni 1122/1
721 00 Ostrava Svinov
Mercor © 2024 All rights reserved.
Projekt i wykonanie:Wiselimber Interactive